PCD INFO

steve

Jr. Member

Karma: 0
Posts: 31

PCD INFO

« on: December 24, 2008, 07:57:07 PM »

Just wanted to know about studs,most wheels i look at say 100mmdia.,reliant axle studs are 4"x4" a differance of 1.6mm,surely this may pose problems? would appreciate some feedback. Thanks.


	Logged

BikerGran

Hero Member

Karma: 94
Posts: 10604

Gran Turismo

Re: PCD INFO

« Reply #1 on: December 24, 2008, 09:55:03 PM »

I know nothing but I'm sure there's some info on the main site...........

Ah yes, clicky Here

Hope what you need to know is in there somewhere!


	Logged

You don't stop havin fun because you get old - you get old if you stop havin fun!

Manky Monkey

Administrator
Hero Member

Karma: 264
Posts: 55102

Re: PCD INFO

« Reply #2 on: December 25, 2008, 12:28:35 AM »

Hiya Steve,
this has been discussed a couple of times on the forum. Yes, obviously, ideally you should be using Imperial sized wheels with Imperial studs, but as you say, the difference is 1.6mm. Less than 3/4 of a millimetre per stud. A couple of fag papers worth. Bolt the wheels on & take 'em off again a couple of dozen times & the studs & wheel holes will wear more than that. If you're not happy then please don't use them, but all I can say is we've been mixing Metric & Imperial for years with no problems at all.


	Logged

On the last freedom moped out of Nowhere City.

Pages: [1]

« previous next »