trike project

[terry t]

Reliant trike project
Soft tail custom frame all ready set up for engine and gear box
Reliant axle not sure what ratio will check. All ready set up for callipers and 12mm wheel studs fitted
Disc brake conversion. Carrier’s callipers pads disc
One complete engine. One with sump and head removed and one block plus 3 head needs skimming I don’t know the condition of any of these as I have not heard them run
Various parts distributors manifolds new shells. 
Three gear boxes. Two pre engaged starter type.  one older type
Two starter motors one of each
Two set forks. Xs250 i think and gpz600 no bars
This still needs work but the engine gearbox with prop and back axle is all ready set up there is a photo of the frame on here I will try and find it or post a new one
The head stock needs some work for the bearings. Ether have shims made or cut and fit new one
This is a good start for some on wanting to build a trike.
I have not got the time to do this as I want to sort my road trike out and this is just sitting there
All above £600
I can deliver if you want it at 50p a mile one way from PO6

[skiprat]

did this come from Devon way? the parts list sounds a bit like all the gear I sold for a mate.

tube frame with swingarm setup on bearings, and nice rack on the back?

[terry t]

did this come from Devon way? the parts list sounds a bit like all the gear I sold for a mate.

tube frame with swingarm setup on bearings, and nice rack on the back?

Hi yes it did. i spoke to you about the forks. i think the swing arm setup is bronze or brass bushes
so you will know the builder

[skiprat]

aha yes, I sold it on behalf of a mate to Pasty man Jan, down in Plymouth

it was the large collection of engines and gearboxes that gave it away LOL

did have all new rear calipers and disks with it, they were worth the money alone

shame its getting passed on again.

[terry t]

aha yes, I sold it on behalf of a mate to Pasty man Jan, down in Plymouth

it was the large collection of engines and gearboxes that gave it away LOL

did have all new rear calipers and disks with it, they were worth the money alone

shame its getting passed on again.

yes i just dont seem to have the time now. want to just get out and ride the goldwing trike