|
Title: GSX 11 fighter Post by: chopper charlie on August 14, 2011, 08:02:16 AM GSX1100 fighter...
Built around a s-reg gs1000 headstock, shoertened and braced, 2" slabs holding 1100WP usd's with new tubes, billet 6's on PFM cast iron discs (got a grands worth of brakes up front), Vulcan tank, suzuki seat unit moulded to carry gas bottle & cut away for micron exhaust to run through, 916 arm and wheel with direct shock mount (done away with rising rate link) and CBR1000 shock,, Yoshi hangers, Stainless outrigger with lay shaft supported by 2 bearings instead of using a dished sprocket Now the good bit... GSX 1100et motor, bored to 1170 using cosworth forged pistons, gasflowed head, Yoshi cams, bigger carbs, had it dyno'd at 141bhp at the wheel. i have just re-built the bike and stuck a NOS kit on using 60 horse jets (should push 201bhp when button is hit) Needs wiring and fluids to finish I've got over four an half grand in this bike, but will sell it now for near as near to £3k as possible, or swap for a muscle bike, or supermoto (something upright) This is not just an old gixer or bandit that someone's crashed, covered in crappy bolt on parts and called a fighter It's a complete one off Don't really wanna sell it, but i've just had major surgery on my knee and i can't even sit on this bike never mind ride it. http://i910.photobucket.com/albums/ac307/chopper-charlie/s1002-1.jpg[/img]](http://i910.photobucket.com/albums/ac307/chopper-charlie/s1002-1.jpg) (http://[img width=600 height=450) http://i910.photobucket.com/albums/ac307/chopper-charlie/s1003-1.jpg[/img]](http://i910.photobucket.com/albums/ac307/chopper-charlie/s1003-1.jpg) (http://[img width=600 height=450) |